For years, hydraulics was practically the only option for moving large industrial loads. Presses, compactors, recycling machinery and lifting systems relied on pumps, valves and hydraulic cylinders because there were no electric alternatives able to
Industrial mechanical redesign is used to correct problems of energy consumption, vibration, premature wear and lack of precision in machinery that keeps running but no longer works under efficient conditions. Many industrial lines keep operating
Hydraulic systems are losing viability in modern military operations. Electromechanics replaces them with ±0.1 mm precision, guaranteed operation from -10°C to 50°C, silent operation below 70 dB, and predictive rather than preventive maintenance. While hydraulic
Integrating a PLC and reprogramming old machinery lets you extend the equipment’s service life; it gives you more control over the process and adapts the machine to new needs without replacing the whole installation. The
Reprogramming an industrial PLC without stopping production is possible when the system allows online changes and the process is under control. If it isn’t done this way, any modification can cause failures or unexpected stops
In many mechanical components, stresses do not act in isolation. Tension, compression, bending and torsion appear at the same time. Combined stress simulation makes it possible to understand how the part really responds in service.
In industrial frames subjected to dynamic loads, the problem is not usually an immediate failure. The problem appears over time, when small repeated stresses end up causing cracks and unexpected stoppages. That is where fatigue
On 16 December 2025, the Spanish Association of Science and Technology Parks (APTE) published its annual list of the 100 most outstanding startups of the year. Kernova is part of that group. The list brings
When an old hydraulic injection moulding machine starts to lose performance, the most repeated question is how much it might cost to convert it to a modern electric system. An injection moulding machine has heavy
PID control systems are a vital tool in industry for effectively managing and optimizing processes. These controllers have proven their reliability across sectors such as water treatment, oil and gas, construction, and heavy machinery. But
